These are important Data Guard properties, most definitely, and must be carefully understood and implemented.
Incremental backups are similar in function to archived logs and RMAN uses them in favor of archived logs during recovery.
Various Primary and Standby database settings are verified by this step, as can be seen in figure 18.
Oracle Recovery Manager RMAN Backup Demos - PSOUG.org
Flashback Archive named FL_ARCHIVE which resides in the tablespace TBS_ARCH and holds information for 1 year.
This further enhanced the setup process of the Data Guard configuration, and also included a monitoring interface for the entire configuration.
To exercise more control over the instances on which the job should run, the SERVICE_NAME parameter can be mentioned where SERVICE_NAME must be a valid known service of the database.
Oracle database Backup and Recovery FAQ - Oracle FAQ
The target disks on the recovery system will need to be configured similarly and the new ZFS pools will need to be sized appropriately.
Note that the system is not installed from this media, but rather, the media is used only to boot the system.
Once the boot device is selected, it is configured as required, based upon the initial disk configuration on the archived system.
Creating an Oracle 12c Data Guard Active Standby Database .
As it was told above, Flashback Data Archie technology stores data in Compressed and Partitioned format.
LEVEL 1 CUMULATIVE indicate that only the blocks that have changed since the last level 0 backup will be backed up.
Can be parallelized across a subset of the available instances of a RAC database by specifying the SERVICE_NAME parameter.
Disaster Recovery Plan (DRP): How to transition to Alternate Process Mode . Storage Area Network (SAN): disk network supports remote backups, data sharing and data migration between different geographical .data center and disaster recoveryppt.